This bulkhead fitting is for connecting plumbing through the liner or side of your water garden or pond. Both sides of the bulkhead are FPT (female pipe thread).
Dimensions in illustration: A = 1 in. NPT (25mm), B = 1 7/8 in. (47mm), C = 2 1/16 in. (52mm), D = 2 7/8 in. (72mm)
- Material: Polypropylene
- Manufacturer Part Number: WP197-1-BLK
- Manufacturer: Winnipeg Plastics & Tool LTD
How to Install a Bulkhead Fitting.
Remove the sealing gasket and use it as a pattern to cut the hole.
Place the gasket over the area where the bulkhead will be installed and mark on the inside of the gasket. When cutting the hole in hard plastic or fiberglass it is best to use a hole saw. Use a breakaway type knife or other small blade sharp knife to cut a clean hole when installing the bulkhead in a flexible pond liner.
The bulkhead can be installed with the nut on the inside or the outside of the liner.
Apply a bead of silicone sealant or lap sealant to the gasket and place this on the wet side of the installation. The sealant will act as a lubricant to keep the liner from bunching up and also help to create a watertight seal.
Tighten the nut to the point that the gasket is crushed against the liner. Install a male adapter to attach your plumbing to the bulkhead. You can then glue pipe into this adapter to finish the installation.
We recommend the use of flexible PVC pipe to allow some movement to relieve any stress that could be exerted on the bulkhead fitting.
Questions about the Bulkhead Fitting 1 inch?
AquaNooga is a team of water feature experts dedicated to helping you get the maximum enjoyment out of your koi pond, water garden, or fountain. Please contact us for help with your pond or water feature questions or needs relating to products and orders. Click Here